HAS-Motion Software Documentation

User Tools

Site Tools

You are here: Main Page » other » inspect3d » documentation » dialogs » Auto Populate Groups
other:inspect3d:documentation:dialogs:auto_populate_groups

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
other:inspect3d:documentation:dialogs:auto_populate_groups [2024/12/17 19:16] – wikisysopother:inspect3d:documentation:dialogs:auto_populate_groups [2024/12/17 20:07] (current) – [Get Signals from] wikisysop
Line 9: Line 9:
  
 =====Dialog===== =====Dialog=====
- 
- 
  
 ==== Auto Build Settings File ==== ==== Auto Build Settings File ====
Line 18: Line 16:
 a) browse for a settings file stored on a local PC\\ a) browse for a settings file stored on a local PC\\
 b) save the existing settings as an .xml file\\ b) save the existing settings as an .xml file\\
- 
  
 ==== Get Signals from ==== ==== Get Signals from ====
Line 25: Line 22:
  
 This section will create a query and condition for each signal in the folder specified. This section will create a query and condition for each signal in the folder specified.
-\\ 
- 
- 
  
 ==== Combine sides? ==== ==== Combine sides? ====
Line 52: Line 46:
      * The **Right Dominant Tag** and **Left Dominant Tag** parameters describe which motion file tags are used to indicate that the relevant pitcher/hitter is right- or left-dominant respectively. The **Dominant Arm Label**, **Nondominant Arm Label**, **Lead Leg Label**, and **Trail Leg Label** parameters allow you to specify how signals for each limb will be prefixed. Finally, the start event and end event define the event sequence for extracting traces from the signal.      * The **Right Dominant Tag** and **Left Dominant Tag** parameters describe which motion file tags are used to indicate that the relevant pitcher/hitter is right- or left-dominant respectively. The **Dominant Arm Label**, **Nondominant Arm Label**, **Lead Leg Label**, and **Trail Leg Label** parameters allow you to specify how signals for each limb will be prefixed. Finally, the start event and end event define the event sequence for extracting traces from the signal.
  
 +\\
 ==== Compare conditions using tags ==== ==== Compare conditions using tags ====
  
other/inspect3d/documentation/dialogs/auto_populate_groups.1734462988.txt.gz · Last modified: 2024/12/17 19:16 by wikisysop