Differences

This shows you the differences between two versions of the page.

--- set_animate_multiple_files [2024/08/27 14:16] – wikisysop
+++ set_animate_multiple_files [2024/10/08 20:52] (current) – wikisysop
@@ Line 3: / Line 3: @@
 <code>
 Set_Animate_Multiple_Files
-! /FILE_NAME=
+/PRIMARY_FILE_NAME=
-! /EVENT_SEQUENCE=
+/PRIMARY_EVENT_SEQUENCE=
+/PRIMARY_EXCLUDE_EVENTS=
+/PRIMARY_X_OFFSET=
+/PRIMARY_Y_OFFSET=
+/PRIMARY_Z_OFFSET=
+/FILE_NAME=
+/EVENT_SEQUENCE=
 ! /EXCLUDE_EVENTS=
 ! /VIEW_DIALOG=TRUE
+/X_OFFSET=
+/Y_OFFSET=
+/Z_OFFSET=
+/COLOR=
 ;
 </code>
+The Command parameters are divided into the primary and secondary.
+Primary is the active file in the workspace. \\
+Secondary are the additional files to be synchronized.
+PRIMARY_FILE_NAME \\
+ Sets the active file in the animation viewer \\
+PRIMARY_EVENT_SEQUENCE= \\
+PRIMARY_EXCLUDE_EVENTS= \\
+ An event sequence for the primary file. Only the first instance of the event sequence will be used. \\
+PRIMARY_X_OFFSET=\\
+PRIMARY_Y_OFFSET=\\
+PRIMARY_Z_OFFSET=\\
+ If the primary offset is blank or is set to a number, the number is the offset\\
+ Using an expression is a special case. The expression doesn't see an offset per se,
+but it sets a based value which is subtracted from the offset of the secondary files.\\
+Secondary are the additional files to be synchronized.
+FILE_NAME=\\
+ Sets the names of the files to be synchronized. Wildcards can, and probably should, be used
+EVENT_SEQUENCE=\\
+EXCLUDE_EVENTS=\\
+ An event sequence for the secondary files. Only the first instance of the event sequence will be used. \\
+X_OFFSET=\\
+Y_OFFSET=\\
+Z_OFFSET=\\
+ Specified as an expression (in this case a number is an expression).\\
+ If the primary offsets are specified, and the expression is a signal, the value of the signal at the event sequence
+is subtracted from the primary offset.\\
+/COLOR=\\
+The color is specified as a RGB hex value or a basic color such as RED or BLUE
+/VIEW_DIALOG=TRUE\\
+The dialog for the animation is automatically launched
+Example. The proximal end of the right foot is aligned across all files based on
+the value at the event label RHS
+<code>
+Set_Animate_Multiple_Files
+/PRIMARY_FILE_NAME=*R_0001.c3d
+/PRIMARY_EVENT_SEQUENCE=RHS+RHS
+! /PRIMARY_EXCLUDE_EVENTS=
+/PRIMARY_X_OFFSET=KINETIC_KINEMATIC::RFT::ProxEndPos::X
+/PRIMARY_Y_OFFSET=KINETIC_KINEMATIC::RFT::ProxEndPos::Y
+/PRIMARY_Z_OFFSET=KINETIC_KINEMATIC::RFT::ProxEndPos::Z
+/FILE_NAME=*R_0002.c3d+*R_0003.c3d+*R_0004.c3d
+/EVENT_SEQUENCE=RHS+RHS
+! /EXCLUDE_EVENTS=
+! /VIEW_DIALOG=TRUE
+/X_OFFSET=KINETIC_KINEMATIC::RFT::ProxEndPos::X
+/Y_OFFSET=KINETIC_KINEMATIC::RFT::ProxEndPos::Y
+/Z_OFFSET=KINETIC_KINEMATIC::RFT::ProxEndPos::Z
+/COLOR=RED+#0001FF
+;
+</code>