Differences

This shows you the differences between two versions of the page.

--- sift:documentation:troubleshooting [2024/07/16 19:24] – created sgranger
+++ sift:documentation:troubleshooting [2025/03/21 18:58] (current) – [Working Data] wikisysop
@@ Line 3: / Line 3: @@
 Listed below are the solutions to common problems that have been reported to the Has-Motion support team. For step-by-step instructions on how to use the various features available in Sift visit our [[Sift:Tutorials:Tutorial_Overview|Tutorials Page]]. If you have a problem that has not been covered below or in the Sift tutorials feel free to e-mail the support team at support@has-motion.ca.
-\\
@@ Line 19: / Line 18: @@
   * Plotted Workspaces (works on entire workspace, even if only one trace/C3D is plotted)
-== All Workspaces ==
+=== All Workspaces ===
 Only perform work on the groups that are plotted in the active plot.
@@ Line 34: / Line 33: @@
 If you plot data and there are empty data points, you may end up with a straight line at -9999999:
-{{DataMissingGraph.png}}
+{{:DataMissingGraph.png}}
 Most calculations (mean, standard deviation, etc) will handle empty data points without an issue, so you can choose not to plot data not found:
@@ Line 44: / Line 43: @@
 You can also choose to exclude this data by selecting this data, right clicking -> Exclude -> Exclude trace (raw data).
-{{AdjustedDataMissingGraph.png}}
+{{:AdjustedDataMissingGraph.png}}
 **NOTE:** Most calculations handle data not found, however, the input to PCA should not contain any missing data points.