visual3d:documentation:definitions:support_format
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| visual3d:documentation:definitions:support_format [2025/03/26 19:19] – wikisysop | visual3d:documentation:definitions:support_format [2025/03/26 19:20] (current) – wikisysop | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| Since the CMO file is most likely too large to e-mail, you can close all dynamic trials (except the relevant C3D file). | Since the CMO file is most likely too large to e-mail, you can close all dynamic trials (except the relevant C3D file). | ||
| - | |**1. Open the relevant CMO file**\\ \\ Make sure the active file is set to ALL_FILES\\ \\ Note that the black circle for all files in the workspace will be listed as ACTIVE | + | |**1. Open the relevant CMO file**\\ \\ Make sure the active file is set to ALL_FILES\\ \\ Note that the black circle for all files in the workspace will be listed as ACTIVE |
| - | |**2. Remove C3D from list of active files**\\ \\ 1. Click in the black circle next to the C3D file (or files) you want to **KEEP** in the CMO\\ \\ 2. The circle of the selected file will be filled in white, and the active file will change to MULTIPLE_SELECTION | + | |**2. Remove C3D from list of active files**\\ \\ 1. Click in the black circle next to the C3D file (or files) you want to **KEEP** in the CMO\\ \\ 2. The circle of the selected file will be filled in white, and the active file will change to MULTIPLE_SELECTION |
| - | |**3. Close C3D files**\\ \\ Go to File -> Close | {{: | + | |**3. Close C3D files**\\ \\ Go to File -> Close | {{ : |
| - | |**4. Review File**\\ \\ Only the selected file should remain in the workspace\\ \\ Make sure that the files in the workspace depict the problem you are having | + | |**4. Review File**\\ \\ Only the selected file should remain in the workspace\\ \\ Make sure that the files in the workspace depict the problem you are having |
| - | |**5. Save modified File**\\ \\ Go to File -> Save Workspace As..\\ \\ Make sure not to overwrite your original CMO file. | {{: | + | |**5. Save modified File**\\ \\ Go to File -> Save Workspace As..\\ \\ Make sure not to overwrite your original CMO file. | {{ : |
| ==== Questions on Specific Signals ==== | ==== Questions on Specific Signals ==== | ||
visual3d/documentation/definitions/support_format.txt · Last modified: 2025/03/26 19:20 by wikisysop