Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:modeling:landmarks:landmark_types [2024/07/16 19:26] – created sgranger
+++ visual3d:documentation:modeling:landmarks:landmark_types [2024/07/17 15:45] (current) – created sgranger
@@ Line 1: / Line 1: @@
-====== Landmark_Types ======
+====== Landmark Types ======
 Landmarks provide a powerful method of representing significant locations within space or locations defined by the model. Landmarks are created by either specifying a location in a segment coordinate system or by transforming markers or other landmarks into a significant location.
@@ Line 46: / Line 46: @@
 In the image below, the **RAnkleCenter** is the point that is created by projecting the **RHL** heel marker onto the line created from the lateral and medial ankle markers **RLA** and **RMA**.
-{{landmark_point_projected_onto_a_line.jpg}}
+{{:landmark_point_projected_onto_a_line.jpg}}
 Another example can be found on this page, [[Visual3D:Documentation:Modeling:Landmarks:Projecting_a_marker_onto_a_line|Project onto a line]].
@@ Line 56: / Line 56: @@
 In the image below, the **RPPinPlane** is the point that is created by projecting the **RPP** marker on the illiac crest onto the plane created from the right and left ASIS's (**RASI**,**LASI**) and the right PSIS **RPS** marker.
-{{landmark_point_projected_onto_a_plane.jpg}}
+{{:landmark_point_projected_onto_a_plane.jpg}}
 == Example 1: Project the hip joint onto a plane passing through the GT's ==
@@ Line 110: / Line 110: @@
 Landmarks can be created relative to 3 locations. This can be handy when removing markers in the motion trials.
-{{landmark3a.jpg}}
+{{:landmark3a.jpg}}
-{{landmark3b.jpg}}
+{{:landmark3b.jpg}}
 A right handed orthogonal coordinate system is defined by the three points (P1, P2, P3).