Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:modeling:segments:modify_segment_coordinate_system [2024/07/12 14:01] – created sgranger
+++ visual3d:documentation:modeling:segments:modify_segment_coordinate_system [2024/07/17 15:45] (current) – created sgranger
@@ Line 1: / Line 1: @@
-====== Modify_Segment_Coordinate_System ======
+====== Modify Segment Coordinate System ======
 The segment coordinate system for all Visual3D segments are defined consistently. When a segment is created in Visual3D the default segment coordinate system is consistent with the [[Visual3D:Documentation:Definitions:Laboratory_Coordinate_System|laboratory coordinate system]].
-{{SegmentCoordinateSytems.gif}}\\
+{{:SegmentCoordinateSytems.gif}}\\
 For example, the following laboratory coordinate system will result in the following default segment coordinate system.
-{{LaboratoryCoordinateSystemDialog.png}}\\
+{{:LaboratoryCoordinateSystemDialog.png}}\\
-{{SegmentCoordinateSystemDialog.jpg}}\\
+{{:SegmentCoordinateSystemDialog.jpg}}\\
@@ Line 18: / Line 18: @@
 This is one of the consequences of the fact that the hands and the feet are considered distal segments; somewhere in the body two proximal ends must meet (e.g. often this is between the pelvis and the thorax/ab segment). To work around this so Visual3D can create a "joint", the thorax segment is defined as stated in the previous paragraph. This means that for this thorax/ab segment that the z-axis points down.
-{{thoraxSCSdown.jpg}}\\
+{{:thoraxSCSdown.jpg}}\\
@@ Line 35: / Line 35: @@
 **Note that Visual3D will only let you create a Right Hand Coordinate system.**
-{{thoraxSCS.jpg}}\\
+{{:thoraxSCS.jpg}}\\
 change the selections as follows:
-{{thoraxSCSmodified.jpg}}\\
+{{:thoraxSCSmodified.jpg}}\\
 The resulting segment coordinate system is now pointing up
-{{thoraxSCSup.jpg}}\\
+{{:thoraxSCSup.jpg}}\\