visual3d:documentation:modeling:segments:segment_to_cofp_distance
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| visual3d:documentation:modeling:segments:segment_to_cofp_distance [2024/06/14 17:24] – created sgranger | visual3d:documentation:modeling:segments:segment_to_cofp_distance [2024/07/17 15:45] (current) – created sgranger | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== COP Distance to Segment | + | ====== Segment to COFP Distance ====== |
| + | |||
| + | ===== COP Distance to Segment ===== | ||
| The **segment to center of forceplatfrom distance** is the maximum distance to look when assigning segments to forceplatforms used in the motion files. The value indicates the distance from the COP of the force platform the foot's center of mass. | The **segment to center of forceplatfrom distance** is the maximum distance to look when assigning segments to forceplatforms used in the motion files. The value indicates the distance from the COP of the force platform the foot's center of mass. | ||
| Line 7: | Line 9: | ||
| The COP Distance is a threshold distance that must be satisfied in order to identify a force assignment. If the distance is too small, and the COP error is a little too high, a recognizable assignment might not be made. **The default value of 0.2m has proven to be an acceptable value, so users should refrain from modifying this value unless they have a very good reason.** | The COP Distance is a threshold distance that must be satisfied in order to identify a force assignment. If the distance is too small, and the COP error is a little too high, a recognizable assignment might not be made. **The default value of 0.2m has proven to be an acceptable value, so users should refrain from modifying this value unless they have a very good reason.** | ||
| - | ===== Change default value ===== | + | ==== Change default value ==== |
| To change the Visual3D' | To change the Visual3D' | ||
| Line 14: | Line 16: | ||
| - Change the value in the **Set the distance of FP Center of Force Pressure to nearest segment** dialog box | - Change the value in the **Set the distance of FP Center of Force Pressure to nearest segment** dialog box | ||
| - | ===== Change value for specific model ===== | + | ==== Change value for specific model ==== |
| To change the value for an individual subject: | To change the value for an individual subject: | ||
| Line 24: | Line 26: | ||
| Once the value has been changed, make sure to Build Model and then Recalc to update the force assignments. | Once the value has been changed, make sure to Build Model and then Recalc to update the force assignments. | ||
| - | |||
| - | Retrieved from "" | ||
visual3d/documentation/modeling/segments/segment_to_cofp_distance.1718385893.txt.gz · Last modified: 2024/06/14 17:24 by sgranger