visual3d:documentation:pipeline:event_commands:event_maximum
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
visual3d:documentation:pipeline:event_commands:event_maximum [2025/04/29 18:21] – [Example 2: Complex] wikisysop | visual3d:documentation:pipeline:event_commands:event_maximum [2025/04/29 19:04] (current) – wikisysop | ||
---|---|---|---|
Line 81: | Line 81: | ||
**Select Frame Offset:** 0\\ | **Select Frame Offset:** 0\\ | ||
**Signal Components: | **Signal Components: | ||
- | **Event Sequence: | ||
**Event Sequence Instance: | **Event Sequence Instance: | ||
- | {{:Event_Max_RKFlex_MaxLocal.jpg?400}} | + | |{{:visual3d: |
+ | Event_Maximum | ||
+ | / | ||
+ | / | ||
+ | / | ||
+ | / | ||
+ | / | ||
+ | ! / | ||
+ | ! / | ||
+ | ! / | ||
+ | ! / | ||
+ | ! / | ||
+ | ! / | ||
+ | ! / | ||
+ | ! / | ||
+ | ! / | ||
+ | / | ||
+ | ! / | ||
+ | ; | ||
+ | </ | ||
2. Close the dialog, on the Signals and Events tab, select the desired signal from the data tree, in this case **Right_Knee_Angle**. Navigate into the LINK_MODEL_BASED items folder, and select the checkbox beside the signal. | 2. Close the dialog, on the Signals and Events tab, select the desired signal from the data tree, in this case **Right_Knee_Angle**. Navigate into the LINK_MODEL_BASED items folder, and select the checkbox beside the signal. | ||
Line 94: | Line 112: | ||
**RKFlex_MaxLocal** will be created at the maximum values during the full gait cycle. As seen below: | **RKFlex_MaxLocal** will be created at the maximum values during the full gait cycle. As seen below: | ||
- | {{: | + | |{{: |
==== Example 2: Complex ==== | ==== Example 2: Complex ==== | ||
- | In this example, the local maxima of the right foot vertical | + | In this example, the local maxima of the right foot angular |
Use the Event_Maximum command to find the peaks in the acceleration signal, the component is set to Y and frame window is increased to 60. | Use the Event_Maximum command to find the peaks in the acceleration signal, the component is set to Y and frame window is increased to 60. |
visual3d/documentation/pipeline/event_commands/event_maximum.1745950904.txt.gz · Last modified: 2025/04/29 18:21 by wikisysop