visual3d:documentation:pipeline:event_commands:event_tpr_signal
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| visual3d:documentation:pipeline:event_commands:event_tpr_signal [2025/04/25 16:20] – wikisysop | visual3d:documentation:pipeline:event_commands:event_tpr_signal [2025/04/25 19:12] (current) – [Examples] wikisysop | ||
|---|---|---|---|
| Line 102: | Line 102: | ||
| For the **Pattern File**, I have it set for the trial which contains the pre-determined events. This will essentially be applying the same logic that goes for one side of the participant' | For the **Pattern File**, I have it set for the trial which contains the pre-determined events. This will essentially be applying the same logic that goes for one side of the participant' | ||
| - | After this pipeline command has been run, the RHS event will begin to show as well. | + | After this pipeline command has been run, the RHS event will begin to show as well. However, if you were to graph the R Hip Angle, you may notice that there are many more occurrences than expected, the number of frames being evaluated may need to be changed in order to better represent the number of occurrences. The following adjustment was made: |
| + | |||
| + | < | ||
| + | / | ||
| + | </ | ||
| + | |||
| + | The following image shows both the Left and Right Hip Angles with the highlighted events (Blue- LHS, Red- RHS): | ||
| + | |||
| + | {{: | ||
| ===Example 2=== | ===Example 2=== | ||
visual3d/documentation/pipeline/event_commands/event_tpr_signal.txt · Last modified: 2025/04/25 19:12 by wikisysop