Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:signal_commands:interpolate [2024/06/17 18:23] – created sgranger
+++ visual3d:documentation:pipeline:signal_commands:interpolate [2024/07/17 15:46] (current) – created sgranger
@@ Line 1: / Line 1: @@
+====== Interpolate ======
 If there are unreliable data points (residuals < 0) in any signal it is possible to interpolate these gaps in the data using a spline interpolation.
-===== Visual3D Version 4 =====
+==== Visual3D Version 4 ====
 The interpolation procedure performs a least-squares fit of an nth order polynomial to k data points.
@@ Line 22: / Line 20: @@
 |**/Maximum_Gap=**     |The maximum number of frames of data that can be replaced with interpolated values.                                   |
-[[InterpolateDlg.png]]
+{{:InterpolateDlg.png}}
 Dialog that pops up when pipeline selection is edited by double clicking with the left mouse button.
-==== Using an expression in Version 4 ====
+=== Using an expression in Version 4 ===
 This is considerable more klunky because it requires 3 commands instead of 1:
@@ Line 53: / Line 51: @@
 ! /POLYNOMIAL_ORDER=3
 **;**
-===== Visual3D Version 5 =====
+==== Visual3D Version 5 ====
 In version 5 we permit the three numerical parameters to have expressions.
@@ Line 67: / Line 65: @@
 ! /POLYNOMIAL_ORDER=3
 **;**
-[[InterpolateDlg2.jpg]]
+{{:InterpolateDlg2.jpg}}
-==== Using an expression in version 5 ====
+=== Using an expression in version 5 ===
 Define the maximum size of the gap based on the POINT frame rate.
-[[InterpolateDlg3.jpg]]
+{{:InterpolateDlg3.jpg}}