Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:signal_commands:set_data_to_new_values [2024/06/19 14:03] – created sgranger
+++ visual3d:documentation:pipeline:signal_commands:set_data_to_new_values [2024/07/17 15:46] (current) – created sgranger
@@ Line 1: / Line 1: @@
+====== Set Data To New Values ======
 This command replaces the following commands:
@@ Line 8: / Line 10: @@
-===== Pipeline Command =====
+==== Pipeline Command ====
 |**Set_Data_To_New_Values**                                                                           |                                                                      |
@@ Line 36: / Line 38: @@
 **Replacement_Value, Threshold_High, and Threshold_Low** can be Expressions
-===== Example: Using a Metric values as the low threshold =====
+==== Example: Using a Metric values as the low threshold ====
-{{Set_Data_To_New_Values_Example_Dlg.jpg}}
+{{:Set_Data_To_New_Values_Example_Dlg.jpg}}
 This example could use an expression instead of simply a metric value
-{{Set_Data_To_New_Values_Example_Dlg2.jpg}}
+{{:Set_Data_To_New_Values_Example_Dlg2.jpg}}
 \\
-===== Example: Change missing data to zero =====
+==== Example: Change missing data to zero ====
 Visual3D has a special number which we refer to as DATA_NOT_FOUND.
@@ Line 56: / Line 58: @@
 \\
-{{Set_Data_To_New_Values_3.jpg}}
+{{:Set_Data_To_New_Values_3.jpg}}