Differences

This shows you the differences between two versions of the page.

--- visual3d:overview:testing_setup_checklist [2024/06/17 18:24] – created sgranger
+++ visual3d:overview:testing_setup_checklist [2024/07/12 13:31] (current) – removed sgranger
@@ Line 1: / Line 1: @@
-When completing process oriented tasks, checklists are important part of the process. A thorough explanation of the benefits of checklists can be fount in [[http://gawande.com/the-checklist-manifesto|The Checklist Manifesto]]
-There are many crucial steps in collecting "routine" motion capture data.
-The following checklist is a starting point from which Motion Capture Laboratories can build their own.
-We encourage users to contribute to this list by sending additional tasks to support@c-motion.com
-===== Before Patient's Arrival =====
-====  Turn on ALL systems ====
-====  Verify Position and Orientation ====
-Verify the position and orientation of Motion Capture Cameras
-Verify the position and orientation of Force Platforms
-Verify the position and orientation of Force Structures
-Verify the position and orientation of Obstacles or Environment objects
-====  Perform System Calibration ====
-Perform static and/or dynamic calibrations of data collection devices
-Verify results against the Standards developed/referenced by your laboratory
-====  Verify the protocol being used for the session ====
-Verify the experimental protocol for the current data collection session
-====  Set appropriate system settings ====
-As per experimental protocol, set and verify system settings
-e.g. sampling rates (synchronise), marker thresholds, ranges, triggers etc.
-====  Zero Force Plates and Perform CalTester test ====
-Perform Caltester test at a minimum of 2 locations on each force platform
-Verify against prior laboratory results
-====  Prepare necessary markers and supplies ====
-===== Patient's Arrival =====
-====  Obtain informed consent ====
-====  Record subject details ====
-Insure that there are no contraindications for the patient completing the data collection
-This may include data collection done via questionnaires or measurements
-If data collection includes patient questionnaires check to make sure that they have been completed correctly
-====  Apply markers as per experimental protocol ====
-Take a set of digital pictures of the subject for post-hoc review of the marker placement.
-====  Record static calibration trial ====
-Ensure all markers are visible
-====  Verify recorded marker set ====
-Verify recorded marker set by launching Visual3D, creating model, and applying model template appropriate for the protocol
-====  Remove anatomical markers ====
-If necessary, remove anatomical markers not needed for tracking in motion trials
-====  Verify tracking using Real time ====
-If you switch to the real time mode in Visual3D, you can verify that the tracking markers assigned to each segment are appropriate, and that the force vectors make intuitive sense
-====  Record dynamic trials ====
-====  Verify force platform assignments ====
-Load data into Visual3D, assign movement trials to model, and verify force platform assignments
-Remove assignments to partial force contacts
-Remove assignments when two segments are in contact with the same platform.
-====  Execute pipeline for creating event labels. ====
-Verify that these event labels make intuitive sense. If not, data collection should be repeated
-===== After Patient Leaves =====
-====  Clean up work station ====
-====  Execute pipeline for processing ====
-====  Load Report Template ====
-====  Verify the report. ====