Differences

This shows you the differences between two versions of the page.

--- visual3d:overview:testing_setup_checklist [2024/06/26 20:30] – created sgranger
+++ visual3d:overview:testing_setup_checklist [2024/07/12 13:31] (current) – removed sgranger
@@ Line 1: / Line 1: @@
-====== Testing_Setup_Checklist ======
-When completing process oriented tasks, checklists are important part of the process. A thorough explanation of the benefits of checklists can be fount in [[http://gawande.com/the-checklist-manifesto|The Checklist Manifesto]]
-There are many crucial steps in collecting "routine" motion capture data.
-The following checklist is a starting point from which Motion Capture Laboratories can build their own.
-We encourage users to contribute to this list by sending additional tasks to support@c-motion.com
-==== Before Patient's Arrival ====
-===  Turn on ALL systems ===
-===  Verify Position and Orientation ===
-Verify the position and orientation of Motion Capture Cameras
-Verify the position and orientation of Force Platforms
-Verify the position and orientation of Force Structures
-Verify the position and orientation of Obstacles or Environment objects
-===  Perform System Calibration ===
-Perform static and/or dynamic calibrations of data collection devices
-Verify results against the Standards developed/referenced by your laboratory
-===  Verify the protocol being used for the session ===
-Verify the experimental protocol for the current data collection session
-===  Set appropriate system settings ===
-As per experimental protocol, set and verify system settings
-e.g. sampling rates (synchronise), marker thresholds, ranges, triggers etc.
-===  Zero Force Plates and Perform CalTester test ===
-Perform Caltester test at a minimum of 2 locations on each force platform
-Verify against prior laboratory results
-===  Prepare necessary markers and supplies ===
-==== Patient's Arrival ====
-===  Obtain informed consent ===
-===  Record subject details ===
-Insure that there are no contraindications for the patient completing the data collection
-This may include data collection done via questionnaires or measurements
-If data collection includes patient questionnaires check to make sure that they have been completed correctly
-===  Apply markers as per experimental protocol ===
-Take a set of digital pictures of the subject for post-hoc review of the marker placement.
-===  Record static calibration trial ===
-Ensure all markers are visible
-===  Verify recorded marker set ===
-Verify recorded marker set by launching Visual3D, creating model, and applying model template appropriate for the protocol
-===  Remove anatomical markers ===
-If necessary, remove anatomical markers not needed for tracking in motion trials
-===  Verify tracking using Real time ===
-If you switch to the real time mode in Visual3D, you can verify that the tracking markers assigned to each segment are appropriate, and that the force vectors make intuitive sense
-===  Record dynamic trials ===
-===  Verify force platform assignments ===
-Load data into Visual3D, assign movement trials to model, and verify force platform assignments
-Remove assignments to partial force contacts
-Remove assignments when two segments are in contact with the same platform.
-===  Execute pipeline for creating event labels. ===
-Verify that these event labels make intuitive sense. If not, data collection should be repeated
-==== After Patient Leaves ====
-===  Clean up work station ===
-===  Execute pipeline for processing ===
-===  Load Report Template ===
-===  Verify the report. ===