visual3d:tutorials:kinematics_and_kinetics:force_platforms
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| visual3d:tutorials:kinematics_and_kinetics:force_platforms [2025/01/15 19:41] – [Preparing for Tutorial] wikisysop | visual3d:tutorials:kinematics_and_kinetics:force_platforms [2025/01/15 19:42] (current) – [Practical Example] wikisysop | ||
|---|---|---|---|
| Line 101: | Line 101: | ||
| **Troubleshooting Tip:** If the ANALOG signals for the force platform exist, but the FORCE signal is zero, examine the FZ1 graph and verify that the Fz Channel of the ANALOG signals is negative. If not, then the ANALOG scale factor in the C3D file has probably been stored incorrectly by the motion capture software. The scale factor will need to be changed in the motion capture software and/or the file. | **Troubleshooting Tip:** If the ANALOG signals for the force platform exist, but the FORCE signal is zero, examine the FZ1 graph and verify that the Fz Channel of the ANALOG signals is negative. If not, then the ANALOG scale factor in the C3D file has probably been stored incorrectly by the motion capture software. The scale factor will need to be changed in the motion capture software and/or the file. | ||
| - | Continue to the [[visual3d: | + | Continue to the [[visual3d: |
visual3d/tutorials/kinematics_and_kinetics/force_platforms.1736970119.txt.gz · Last modified: 2025/01/15 19:41 by wikisysop