HAS-Motion Software Documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== 3D Calibration ======

The //3D Calibration// widget contains the parameters that control the calculation of the 3D configuration of the X-ray equipment (//i.e.//, the position of the X-ray sources and the positions and orientations of the image planes). You should check that the parameters are specified properly before doing //Tools → Compute 3D Configuration//.

{{:CalDSX_3DCalibrationWidget.png}}

^ Parameter ^ Description ^
| **Image Distance Allowance** | Used when calculating the 3D configuration parameters. It is the amount by which the source-to-image-plane distance is allowed to change from the user-specified value. The default value is 0.0.|
| **Optimize Pixel Size** | Specifies whether or not to optimize the pixel size when calculating the 3D configuration parameters. The default value is false (box is unchecked). |
| **Square Pixels** | Specifies whether or not to force the X and Y pixel sizes to be the same when distortion-correcting the X-ray images. The default value is true (box is checked).|
| **Source To Image** | The distance between the X-ray source and the plane of the image intensifier or flat-panel detector. This distance should be measured carefully in millimeters during data collection, and entered into the subject file with [[Other:DSX:xManager:xManager_Overview|xManager]]. It can also be entered here if 3D calibration has not been performed yet. During 3D calibration, this distance will be optimized by the DLT algorithm if **Image Distance Allowance** is greater than zero, and its updated value will be shown here. |

===== See Also =====

Go back to an overview of [[other:dsx:calibratedsx:calibratedsx_overview#widgets|CalibrateDSX's widgets]].