HAS-Motion Software Documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Set Data To New Values ======

This command replaces the following commands:

Set_Frames_To_Zero\\
Set_Frames_To_New_Values\\


\\


==== Pipeline Command ====

|**Set_Data_To_New_Values**                                                                           |                                                                      |
|**/SIGNAL_TYPES=**                                                                                   |The type of signal to be processed                                    |
|**/SIGNAL_NAMES=**                                                                                   |The names of the signals to be processed                              |
|**/SIGNAL_FOLDER=**                                                                                  |The name of the signal folder                                         |
|**/SIGNAL_COMPONENTS=**                                                                              |The signal components to be modified                                  |
|**/RESULT_SUFFIX=**                                                                                  |Optional Suffix to Add to the Result Name                             |
|**/RESULT_FOLDER=**                                                                                  |The Folder for the Results                                            |
|**/START_FRAME=\**                                                                                   |Start Frame                                                           |
|**/END_FRAME=**                                                                                      |End Frame                                                             |
|**/[[Visual3D:Documentation:C3D_Signal_Types:EVENT_LABEL_Data_Type#Event_Sequence|EVENT_SEQUENCE]]=**|A list of events (separated by "+" signs). For example, LHS+RTO       |
|**/[[Visual3D:Documentation:C3D_Signal_Types:EVENT_LABEL_Data_Type#Exclude_Events|EXCLUDE_EVENTS]]=**|Exclude Sequences containing these Events.                            |
|**/USE_POINT_RATE=**                                                                                 |(true or false) Explicitly uses the motion capture point rate.        |
|**/REPLACEMENT_VALUES=**                                                                             |The new signal value at each frame                                    |
|**/THRESHOLD_HIGH=**                                                                                 |Optional. Replace only if signal values is greater that this threshold|
|                                                                                                     |default=DATA_NOT_FOUND                                                |
|**/THRESHOLD_LOW=**                                                                                  |Optional. Replace only if signal values is greater that this threshold|
|                                                                                                     |default=DATA_NOT_FOUND                                                |

**;**

Set the frames of data from start_frame to end_frame and/or from Start Event to End Event.

If a TARGET signal is set to DATA_NOT_FOUND, all components of the signal are set to DATA_NOT_FOUND.

**Replacement_Value, Threshold_High, and Threshold_Low** can be Expressions

==== Example: Using a Metric values as the low threshold ====

{{:Set_Data_To_New_Values_Example_Dlg.jpg}}

This example could use an expression instead of simply a metric value

{{:Set_Data_To_New_Values_Example_Dlg2.jpg}}

\\


==== Example: Change missing data to zero ====

Visual3D has a special number which we refer to as DATA_NOT_FOUND.

The actual value used internally is -999999

The following command properties will change every occurrence of DATA_NOT_FOUND to 0

\\
{{:Set_Data_To_New_Values_3.jpg}}