====== Metric Frames Between Events ======

Computes the number of frames between events (or start and end of a sequence of events) as a metric. For example, consider Right_Terminal_Double_Limb_Support.

**Note that the frames will be at the POINT RATE because Visual3D computes Events at POINT RATE.**
\\


<code>
Frames_Between_Events
/Event_Sequence=    A list of events (separated by "+" signs). For example, LHS+RTO
/Exclude_Events=    This Event_Sequence must not be during the sequence requested. For example, LTO_RHS
/Metric_Name= The name of the metric signal. For example, Right_Terminal_Double_Limb_Support
/Generate_Mean_And_StdDev=(True or False)Generate the mean and standard deviation for all of the metrics created
/Append to Existing Values=(True or False)Append this list of metrics to an existing metric of the same result name
</code>

\\
\\
Dialog that pops up when pipeline selection is edited by double clicking with the left mouse button.\\
{{:MetricTimeBtwnEventsDlg.jpg}}\\
\\


===== Example =====

\\


|<code>\\ Metric_Frames_Between_Events\\ /RESULT_METRIC_NAME=Right_Terminal_Double_Limb_Support\\ ! /RESULT_METRIC_FOLDER=PROCESSED\\ /EVENT_SEQUENCE=LHS+RTO\\ /EXCLUDE_EVENTS=LTO+RHS\\ ! /GENERATE_MEAN_AND_STDDEV=TRUE\\ ! /APPEND_TO_EXISTING_VALUES=FALSE\\ ;\\ </code>  |  {{:MetricTimeBtwnEventsDlg_Example.jpg}}|

==== Visual3D Versions supporting Subject Prefixes ====

NOTE: When using events in a command, the commands will iterate across subjects contained in the current workspace. As such, events and sequences listed as command parameters should NOT contain a prefix. As each subject is processed, the event range/sequence specified will automatically use the specific events prefixed for each subject as they are processed.