====== Remove Metrics By Threshold ======
====Overview====
The command **Remove Metrics by Threshold** removes metrics above or below a threshold, allowing you to keep those within the range, or outside the range. This can be useful when trying to isolate data within a certain signal range, or when trying to isolate outliers. If a component is removed, all components at that frame are removed. The command can be found within the **Pipeline Workshop** under **Metric**.

====Pipeline Command====

The syntax for the function is as follows:

<code>
Remove_Metrics_By_Threshold
! /METRIC_FOLDERS=
/METRIC_NAMES=
/METRIC_COMPONENTS=
! /REMOVE_METRICS_ABOVE=
! /REMOVE_METRICS_BELOW=
;
</code>

====Command Parameters====

The following table shows the command parameters seen above and their descriptions:
|**Remove_Metrics_By_Threshold**|                                          |
|**/Metric_Names=**             |The names of the metrics                  |
|**/Metric_Folders=**           |The folders of the metrics                |
|**/Metric_Components=**        |The components of the metrics to be tested|
|**/Remove_Metrics_Above=**     |An Expression                             |
|**/Remove_Metrics_Below=**     |An Expression)                            |

====Example====