The properties of the functional joint are defined in the Model BuilderĀ : LandmarksĀ : Functional Tab
The definition of the functional joints can be saved in an INI file for future use, but it is more common to simply save the Model Template because the functional joint definitions (and digitized point definitions) will automatically be saved to the template. The Visual3D template will actually contain two versions of the functional joints. The first is the actual definition, and the second is the resulting explicit value that results from the functional joint computation. This second landmark is the one that is displayed in the viewer and can be used to define a segment or other landmarks.
Alternatively, you can specify a custom landmark name.
Note that you can save and load functional joint definitions to a file for future use.
The landmark will be created relative to the tracking segments/targets. For example, if you look at the definition of the landmark that is created after computing the functional joint, it will reference these segments/targets.
The other segment/targets refers to the segment that is moving relative to the Tracking segments.
Note that the Tracking Targets are colored blue in the viewer and the Other Targets are colored yellow.
Originally, the Tracking was referred to as the Reference
There are 3 options available.
Regardless of whether the user selects Targets or Segments, Visual3D creates a technical coordinate system (TCS) to represent each segment for the computations. This is done to ensure that a segment exists because it is possible that the segment definition depends on the functional joint being computed.
Visual3D chooses the three markers (from however many were selected) to be used for the TCS definition. Three markers define the vertices of a triangle. Visual3D searches for the triangle with the largest area, then uses these 3 targets. Visual3D then searches for the two vertices of the three selected that are the farthest apart, and these become the proximal and distal end of virtual segment from which the TCS is defined. The TCS is tracked, however, with all of the Targets that were selected.
If the resulting landmark is defined relative to Targets (e.g. not to a segment), Visual3D uses the three markers that made up the TCS.
If the resulting landmark is defined relative to a segment, Visual3D transforms the landmark from the TCS into the Segment Coordinate System.
In this case, Visual3D elected to define the landmark relative to RAS, LPP, and RPS of the possible 6 Targets used for tracking the segment.
The same landmark can be defined relative to the pelvis segment rather than to markers.
If you have created the landmark for use in defining segments (e.g. calibration only), it doesn't really matter whether you define the landmark relative to segments or landmarks.
If you have created the landmark and would like to use it for tracking, it is advisable to define the landmark relative to a segment.