Signal Commands Overview

This command will allow you to create custom mathematical expressions.

add_constant_to_signals Adds a constant to the specified components of a signal(s)

Add Random Noise To Signals

add_signals

Add the specified signals. Signals must be at the same sampling rate. If your signals are a different rate, you can use the Evaluate_Expression command, which determines an appropriate rate automatically.

divide_signals

This command will divide signals with the first signal being the numerator.

divide_signal_by_constant

This command will divide a specified components of a signal(s) by a constant.

First Derivative

Compute the first derivative at each point of a signal. This command is useful for calculating the velocity of targets, landmarks, etc.

Second Derivative

Compute the second derivative at each point of a signal. This command is useful for calculating the acceleration of targets, landmarks, etc.

multiply_signals

Multiply the components of the specified signals.

multiply_signals_by_constant

Multiply signals by a constant value.

Indefinite Integral

Compute an indefinite integral from the start event to the stop event.

Signal Magnitude

Calculate the magnitude of a signal.

Magnitude=Sqrt( x^2+y^2+z^2 )

subtract_constant_from_Signals

Subtracts a constant from the specified components of a signal(s)

Subtract Signals

Subtract the components of the specified signals.

Square_Root

Compute the Square Root of a signal or metric. This command can be used to compute the vector magnitude of a signal.

Compute Planar Angle

This command computes a planar angle between three or four points.

Compute Volume Of Chest Wall

compute_volume_of_a_convect_hull

Create Target

Global Normalized Signal Mean

find_representative_signal

Merge Data

This command merges data from more than one data name into a single one either by appending one signal to the end of another signal or by treating each original signal as a component of the new signal.

copy_folder

Makes a copy of an existing folder. If the new folder already exists, select whether these signals should be overwritten (replaced).

rename_folder

This command renames the specified folder.

delete_folder

Deletes the specified folder. Note that ORIGINAL folders can not be deleted.

Remove Signals

Rename Signals

Remove Unlabeled Points

Vicon Nexus exports unlabeled trajectories, and identifies them by placing an asterisk (*) at the beginning of the filename

Remove Polygon Signals

Remove processed signals generated by Polygon and stored as POINT data in the c3d file.

Average Filter

FFT Filter

gcvsp

Lowpass Filter

Highpass Filter

Onepass Filter

Median Filter

Moving RMS

Teager Kaiser Energy

Teager-Kaiser Energy Operator

Shift Frames

Interpolate

Replace

Set Data To New Values

Rectify

First Derivative

Second Derivative

Transform_Data_Coordinate_System

Distance Along Path

Distance Parallel To Path

Distance Perpendicular To Path

Compute UD Power

Cross Correlation

Compute IK Residuals

Compute the intersection of two lines

Compute the intersection of a line with a plane

The head fixation point is the intersection between the anterior direction of the head at one frame of time and an another frame of time. This examples makes use of the example for computing the Intersection of 2 Lines found above.