visual3d:documentation:pipeline:metric_commands:remove_metrics_by_threshold
Table of Contents
Remove Metrics By Threshold
Overview
The command Remove Metrics by Threshold removes metrics above or below a threshold, allowing you to keep those within the range, or outside the range. This can be useful when trying to isolate data within a certain signal range, or when trying to isolate outliers. If a component is removed, all components at that frame are removed. The command can be found within the Pipeline Workshop under Metric.
Pipeline Command
The syntax for the function is as follows:
Remove_Metrics_By_Threshold ! /METRIC_FOLDERS= /METRIC_NAMES= /METRIC_COMPONENTS= ! /REMOVE_METRICS_ABOVE= ! /REMOVE_METRICS_BELOW= ;
Command Parameters
The following table shows the command parameters seen above and their descriptions:
| Remove_Metrics_By_Threshold | |
| /Metric_Names= | The names of the metrics |
| /Metric_Folders= | The folders of the metrics |
| /Metric_Components= | The components of the metrics to be tested |
| /Remove_Metrics_Above= | An Expression |
| /Remove_Metrics_Below= | An Expression) |
Example
visual3d/documentation/pipeline/metric_commands/remove_metrics_by_threshold.txt · Last modified: 2025/09/22 18:32 by wikisysop