visual3d:documentation:pipeline:model_commands:add_landmark_from_event
This is an old revision of the document!
This command will create a Landmark using a Signal Value at a defined Event Label.
| Add_Landmark_From_Event | |
| /SIGNAL_TYPES= | The name of the Signal Type to use. |
| /SIGNAL_FOLDER= | The name of the Signal Folder to use. |
| /SIGNAL_NAMES= | The name of the Signal Name to use. |
| /LINK_MODEL_NAME= | The name of the hybrid model. Use the full pathname. |
| /EVENT= | The name of the Event Label. |
| /LANDMARK= | The name of the Landmark to be created. |
Example
Create a Landmark (DIST_SHAFT) based on the position of the Target (OBJ2) position at the distal end of the golf club shaft at the event TAKEAWAY (i.e. the first movement in a golf swing).
| /SIGNAL_TYPES= | TARGET |
| /SIGNAL_FOLDER= | ORIGINAL |
| /SIGNAL_NAMES= | OBJ2 |
| /LINK_MODEL_NAME= | C:\Static.c3d |
| /EVENT= | TAKEAWAY |
| /LANDMARK= | DIST_SHAFT |
Retrieved from “”
visual3d/documentation/pipeline/model_commands/add_landmark_from_event.1718644068.txt.gz · Last modified: 2024/06/17 17:07 by sgranger