DSX MoCap Tutorial

Under Construction

The DSX Software Suite comes with knee model templates which are created for you. The model templates are used to seed the segment tracking using the motion capture data.

If you use the same marker set with the same marker names, you can use the model templates as is. If you use different marker names, you will need to re-name the markers in the model template. If you use a different marker set, you will need to modify the model template. These changes may be done in Visual3D. Making these changes requires a knowledge of Visual3D.

In your Motion Capture Software

You must reconstruct and label the C3D files.

Some motion capture vendors allow you to export the subject name as a prefix to the target labels. This option must be turned off.

Knee Model

Segments Tracked:

• Pelvis (used to define hip joint center in motion capture only)
• Thigh
• Shank
• Patella (using motion constraints)

Minimal PiG Marker Set (NOT Recommended)
Note: The position of the subject during static calibration matters. The subject's knees should be in line with each other.

Knee Marker Set (Recommended)

Update_DSX_Knee_Model_Template

Cervical Model

Segments Tracked:

• Trunk
• Head
• C7 - C1 (using motion constraints)

Cervical Spine Marker Set
Note: The subject's position during the static trial matters. The subject's head is assumed to be in a neutral position during the static trial.

Lumbar Model

Segments Tracked:

• Pelvis
• Trunk
• L5 - L1 (using motion constraints)

Lumbar Spine Marker Set
Note: The subject's position during the static trial matters. The pelvis is assumed to be vertical during the static trial.